Maxtor STM3250824AS Manual do Utilizador descarregar pdf (Página 33)

APPENDIX C: HARD DISK INSTALLATION

Hard drive jumpers need to be set properly in order to make DVR function correctly.

2. Remove DVR top cover by taking out screws from location shown below:

. Below picture indicates a DVR without a H.D.D installed.

4. Please refer to the instruction from hard drive manufactory for correct jumper setting on (master)

mode of the hard drive, mounting the hard drive over DVR base by facing SATA interface to

DVR main board. Match screw holes from bottom to bottom of hard drive and the DVR. Turn

over the DVR from top to bottom side and then mounting up the hard drive by using screws from

attached accessory pack as picture below:

1 2 ... 28 29 30 31 32 33 34

Sem comentários

Maxtor STM3250824AS Manual do Utilizador Página 33