Maxtor CDR-04S Manual do Utilizador

WARNING1

PLAYPress “ PLAY ” button, the DVR will show the last recording. 1. FAST FORWARD (F.F. ) & FAST REWIND (F.R.)You can increase the speeds of Fast F

ACCESS MENUDetailed Menu SetupThe Menu allows you to configure your DVR settings. Please follow below steps to access the Menu :Password: 0000Press th

MENU OPTIONSDVRSYSTEM1. AUDIO INPUTTo choose one of 4 channels to record. (only can select 1 during operation for recording)(MENU)TIMERRECORDCAMERA ►S

12. CLEAR HDDDelete all the contents of your HDD. When you choose “YES” on this option, you will be prompted with the question shown : Press “►” to cl

RECORD1. HDD OVERWRITESelect “YES” to overwrite previously recorded video in HDD. NOTE : When the HDD is full under O/W Recording mode, previous recor

MOTION DETECTIONDVRMOTION DETECTION SETUP1. Press “ MENU “ to enter the menu set up, then “ Down ” to CAMERA setup.2. Press “ENTER” twice to enter the

Figure 1-1 MOTION DETECTION SETUP — 1~15Figure 1 MOTION DETECTION SETUP1234567 891011 12131415---- -- -- -- -- -- -- -- -- -- -- -- -- --0321234567 89

PICTURE IN PICTURE (PIP)Press PIP button to enter PIP display screen. The PIP format displays a full screen “background” picture with a 1 / 16

DVRKEY LOCKFor added security, you can “Lock” the buttons on your DVR. Locking disables the buttons and prevents other people from using the system.Pr

SPECIFICATIONSDVRVideo formatNTSC/EIA or PAL/CCIRHa rd di sk stora g eIDE type, UDMA 66, supported 250 GB HDDRecord modeManual / Alarm / Timer / Motio

WARNINGDVRAll the safety and operating instructions should be read before operation. The improper operation of this device may cause permanent damage.

APPENDIX #1 – INSTALLING the HDDPlease follow the steps carefully in order to ensure correct installation.The compartment located on the front panel o

4.Secure the HDD in the Casing Use the screws supplied to tighten them, place the HDD into correct position.5.Slide the top Cover over the Cartridge C

APPENDIX #2 – PIN CONFIGURATIONS25 pin com portDVR9 pin com portDVR21

PIN 1. GNDGROUNDPIN 4, 5, 17, 18 ALARM INPUTTo connect wire from ALARM INPUT (PIN 4, 5, 17, 18) to GND ( PIN 1 ) connector, DVR will start recording

APPENDIX #3 – RACK MOUNTScrews and brackets for rack mounting applications can be purchased as an optional accessory.Front Angle with Rock Mount Side

APPENDIX #4 – RECORDING TIMEThe Record Time is different based on Record Speed and Record Quality. Please refer to following table. NTSC SYSTEM25A1584

DVRTABLE OF CONTENTSWhat do you getWhat do you get??‧ FEATURES ---------------------------------------------------------------------------------------

FEATURESWhat do you get ?DVR Features• Wavelet Compression Format replaces Time-Lapse VCR + Multiplexer• 4 Audio inputs / 2 Audio outputs (selectable

INSTALLATION GUIDEBefore Operation1. Connect cameras and monitor with the DVR.2. Shown below is one example for connecting the DVR to your existing Ob

FRONT PANELDVR4213HDDHDD FULLREWFF STOPTIMERALARMPOWERPLAY RECCDR-04SENTERMENU SEARCH SLOWZ00M12345678910111213141516171. REMOVABLE HDD CARTRIDGEPleas

11. POWERPress Power to turn ON / OFF the DVR. 12. FF / Right‧FF : It can play video forward at high speed, and press FF again to adjust speed from 1,

BACK PANELDVRRISK OF ELECTRIC SHOCKDO NOT OPENWARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER (OR BACK).NO USER-SERVICEABLE PARTS IN

START THIS UNITBasic OperationBefore using the DVR, please have a HDD installed ready. (refer to Appendix #1 for installation or removal of a HDD).Con